MICROTEK SCANMAKER maitinimo adapterį keitimas 4800

Tai tik iš rūšių dalykų gaunu žvilgsnis daryti kiekvieną dieną… Savaitę arba tiek atgal aš turėjo klientų, kurie vartojo naudotą skenerį iš draugo. Skaitytuvas buvo Microtek ScanMaker 4800. Buvau šiek tiek susirūpinęs, nes jos kompiuteris vis dar turi "Windows" 98 ir aš prisimenu labai daug ilgas valandas plaukų traukiamosios priėmimo USB skaitytuvai ir Windows 98 darbo metų. Laimei, nors, vairuotojas cd buvo įtraukta į maišą jų draugas praėjo kartu. Diegimo procesas vyko sklandžiai, bet ten buvo vienas smulkmenos trūksta.

If you read the title of this post, you know what, the power adapter. That little blackwall-wartthat takes power from the outlet and actually causes the scanner to run. I have lost track of how many devices I have now that have these ac-dc adapters. In the last few years I’ve collected a box for the leftover ones. For when a network switch fails, or a device that uses batteries comes with the ac/dc adapter. All of those situations I wind up stowing it inthe box”. According to the bottom of the scanner it accepted 12V 1.25 amp input only.

Taip, I told her I would have to look and see if I could find a replacement and revisit. The first stop I made at home wasthe boxto see if there was a suitable match, bet, žinoma,, ne. It seems every device uses a different voltage. (One note on voltages…. always always try to replace adapters like this with a voltage that is as close as possible to the rated voltage. 12V in this case is necessary, 13 technically might work. I have a tendancy not to trust these adapters and test them with my meter first. (Many adapters rated at 5 volts may actually put out 7 V… Generally less voltage could cause the equipment to not work properly, too much could actually burn out components. (A small percentage more should be okay, but as always you should try to match the rated voltage.)

The amperage is a situation where you need at least the rated amperage. More amperage is ok because the device will only draw what it needs. In this case I gave a call to the local Radio Shack to see if they had a 12V adapter that put out that many amps. They did in fact have a 12V, 1.5 Amp adapter which sounds like it would work.

Dabar, as you know, every electronic device ever made uses a different size barrel connector. One of the correlaries to murphy’s law must be that if you have a power adapter it will not match the jack. Radio Shack has theadapt a plugsystem which means they have the barrel plugs separate from the power supplies (which is excellent.) Laimei, there are a few more common sizes, B and M are the most common (Aš turėjau 2 M’s and a B already for some of my equipment.) In this case I didn’t have the device with me when I went to radio shack. (Always a good thing if you’re able to take the device with you.)

So, I opted for the next most popular plugs that were a close match to the size of the power jack on the scanner. K and N were the next most common plugs that looked as though they would match. So, I got one of each.

The bottom line is the adaptaplug tip K with a 12 V adapter is what I used. The fit seemed fairly snug and it seemed as though the scanner performed as it should. When I connected the 12V adapter, adapt a plug K and Microtek Scanmaker 4800 daugiau, it power up and the computer recognized it as a new device. After that a test scan seemed ok I labeled the bottom of the scanner with the adapt a plug size (just in case we needed to replace it again.) Beje, the tip is positive on the adapter.

Susijusios Žinutės

Blog Traffic Exchange Susijusios Žinutės Blog Traffic Exchange Susiję Tinklalapiai
  • Nurodykite Jūsų Nuolaidų Elektriniai įrankiai Dalis priežasties, kad dauguma žmonių nusprendžia padaryti savo remonto ir techninės priežiūros aplink namą, nes tai daug pigiau nei samdyti kažkas tai padaryti. Tačiau, daug darbo vietų reikalauja specialius įrankius, ir ypač rankiniai įrankiai su varikliais gali būti labai brangu. Daug, ......
  • Green Energy Power! Buyer Beware - Using Power Factor Correction and Transient Voltage Surge Suppression to Reduce Energy Costs. Today's energy conscious climate has motivated many to do what they can to become more efficient and conserve energy and money. Unfortunately this same climate has prompted others to take advantage of unsuspecting......
  • How To Be A Skeptical Empiricist In One Easy Lesson I consider myself to be a skeptical empiricist, a philosophical position that's often misunderstood.  Common labels for skeptical empiricists for those not in the know are pessimist, doubter, denier,  and even know-it-all (this last one tends to be true).  In simplified terms, a skeptic is merely someone whose default position......
PDF24    Siųsti straipsnį kaip PDF   

Panašūs Žinutės

Kas atsitiko ši diena istorijoje arba BBC '
Raktiniai žodžiai:
Amazon Logo

Comments are closed.

Perjungti į mūsų svetainę Mobile